The HDMI extender over a single UTP cables with IR control is the right way to send your HDMI signal over long distances. Instead of using expensive HDMI cables, this device lets you use your existing Cat6/7cables/sockets while also performing the same functions like transferring Deep Color video and new lossless compressed audio. And if that weren't enough, you can use your existing remote to control your device through an IR blaster. Specification:
HDMI signal: Comply HDCP
Resolution supported: 480i@60Hz, 480p@60Hz, 576i@50Hz, 576p@50Hz, 720p@50/60Hz, 1080i@50/60Hz, 1080p@50/60Hz Network cable: Low resistance and consumption oxygen-free copper core（CAT6、CAT6A、CAT7）
Transmission length: CAT6:60m at 1080P
IR remote control: Support 20~60KHz wide frequency IR remote control
Working temperature: 0℃～60℃
power consumption: TX：2W； RX<2W
Product size: 2.82(W) x 2.62(D) x0.98(H)inch Package Contents:
1 x HDMI to RJ45 sender TX
1 x RJ45 to HDMI receiver RX
2 x DC5V/1A power
1 x User manual
1 x IR blaster extension cable
1 x IR receiver extension cable Note:
1.High quality cat6 or cat6a cable is needed to work with this hdmi extender,preferably longer than 15 meters/45ft or above
2.Only supports the PCM audio output
3.Do not mix up HDMI to RJ45 sender and RJ45 to HDMI receiver before installation.
4.Do not hot plug when it is working.
5.Make sure the cables in right connection.
6.Please press RX RESET button when no image output.
7.Please make sure the cables follows 568B and reset TX/RX to input HDMI Signal when RX"LINK" Led is flashing all the time.